Bartek

Error code 54 I have test-ecu and I want to be able to connect it to any car (without removing existing ECU, copy immo code, program my ECU) and fast test why car has problems on idle.... In this model of Carisma are many reasons (3 by-pass valves, EGR, high pressure pump, and ECU) - in specyfic case, after change all parts under hood to parts from 100% OK car, we suspect ECU, and it was good shot. Fortunelly we have almost identical Carisma, for engine swap, so all set key, immo, ECU was easy to connect and check.

You can remove, or you can write (PM or @) how to do this?

Pins in immo box are connected phisicaly BTW: Do you know how can I deactivate immo at all?

I made wires to program ECU outside car, and everything works fine Thanks for all advices samsu: K-line and boot pin I've checked from diagnostic connector to inside ECU, Evoscan for logging works fine, so I've no idea what is wrong, but OSP (OutSystem Programming) works good - read and write

No. Do you have ready chart what and where I have to conect (for Carisma '98)? If no, what I have to connect to program: - +12V - +12V Ignition - GND - K-line - boot pin - + 12V to OP2 - GND to OP2 anything else?

only oryginal immo - with transponder borrowed form "source" car, engine starts and everybody are happy, but source car is now destination to 6A13 engine, so I dont want change or dig in keys. I know immo codes, so I have to change only 2 bytes in ECU

He checked out on other computer with XP Pro, and software that You just sent to me On similar ECU (MD355869) this problem is appears too.

He checked out boot pin inside ECU - like on picture

My friend checked out - boot pin inside ECU has 17V too.

K-line I think works OK, because Evoscan works proprely I'll check boot pin - on ECU connector works OK - has 17V while attempt to read

Did You send to ma @? I've got form Hamish and I'm using MMCFlash 0.8.0 build 11

It's a bit dificult - I'll be in garage at evening I've choose MH7201 with and without external memory I've received program yesterday, donge at last friday, so I'm newbee My copmuter works on Win XP Home Edition SP3 I'm sending to You ECU with 8200 form another "proprety" on my garage - I've spoke about this with Hamish

Yes of course My OP2 cable works perfect with Ecuflash and my Legnum VR-4

I have similar problem, but I can't even read ECU - Identity errors MMCFlash + OP2 cable Engine: 4g93 GDI HW: MD351866 E2T68374 CPU: MH7201F Pics: http://www.evoscan.com/helpdesk/download_attachment.php?att_id=167&track=JQ6JU4VYSD http://www.evoscan.com/helpdesk/download_attachment.php?att_id=168&track=JQ6JU4VYSD Any suggestions?